Dyness
Dyness akkumulátorok beállítási útmutatói, hibakódok és hibaelhárítási segédletek telepítők számára.
Dyness hibakódok
- Parallel output phase deficiency
- EMS external Flash abnormality
- Communication abnormal: EMS ↔ HMI
- Communication abnormal: EMS ↔ liquid-cooling unit
- HMI displays: SPD (surge protector) alarm
- RED light always on (discharge state)
- Pressing the "WAKE" button does not turn on the device — light (D) remains OFF
- Abnormal communication between batteries
- EMS power-loss saving abnormality
- Power switch (Reset) / Wake/sleep button not pressed and held 3s
- Parallel host loss (multi-cabinet)
- Communication abnormal: EMS ↔ fire protection module
- Battery shutdown (unexpectedly)
- Power connection short-circuit
- RED light always on; buzzer starts (charge state)
- Inconsistent capacities prevent parallel operation
- HMI displays: Other unspecified alarm
- Pressing "WAKE" turns device ON but the D-light is YELLOW or RED
- Communication abnormal: EMS ↔ meter
- Parallel grid input inconsistency
- Charging voltage is too low
- Communication abnormal: EMS ↔ DCDC
- Network abnormality (4G / WiFi / LAN)
- Incompatible software versions prevent parallel operation
- RED light always on (charge state)
- DC circuit breaker not turned on
- SD card detect abnormality
- Abnormal anti-backflow (export limit) function
- HMI displays: Smoke detector alarm
- SOC jumps during charging / discharging
- Power light OFF
- HMI displays: Access alarm (door open)
- Abnormal communication between battery motherboard and light board
- System version inconsistency between subsystems
- Alarm (FAULT) light ON
- Communication abnormal: EMS ↔ PCS
- HMI displays: Gas detector alarm
- RED light always on; buzzer starts (discharge state)
- Parallel communication loss (multi-cabinet)
- RED light always on; buzzer starts (discharge state)
- Battery voltage is too low
- The battery has no voltage output
- HMI displays: Temperature detector alarm
- HMI displays: Flood alarm (water immersion)
- HMI displays: Emergency stop (EPO) alarm
- Communication abnormal: EMS ↔ air-conditioning / dehumidifier
- Communication abnormal: EMS ↔ BMS
- Parallel input phase sequence error
- Running light OFF